產品名稱：Valve Control Box (FCS539) 閥控箱（FCS539）

Key Features

l  Dedicated channels for inlet port leak testing, outlet port pressure validation and pilot actuation

l  Integral valve sensors for test verification purposes

l  Pilot ramps test to ensure pressure and time measurables are acceptable

l  用于進氣口泄漏測試，出口壓力驗證和先導驅動的專用通道

l  整體式閥門傳感器，用于測試驗證

l  先導斜坡測試，以確保壓力和時間可測量是可以接受的

The FCS539 contains all the required pneumatics to interface FCO750 Leak Detectors with the ports of changeover valves, allowing efficient automatic testing of these parts.

FCS539包含所有必需的氣動裝置，可將FCO750泄漏探測器與轉換閥的端口連接，從而實現對這些部件的高效自動測試。

The FCS539 is controlled by the FCO750’s programmable outputs, driving the required pneumatic / electrical pilots required to control specified pneumatic and solenoid valves on a test by test basis. The respective electrical input signals of the FCO750 ensure internal valves within the FCS539 are in the correct state via the use of optical sensors.

FCS539由FCO750的可編程輸出控制，驅動所需的氣動/電氣控制器，以便在測試基礎上控制指定的氣動和電磁閥。FCO750的相應電氣輸入信號通過使用光學傳感器確保FCS539內的內部閥門處于正確狀態。

An integral gauge pressure switch within the FCS539 verifys the outlet air is either on or off at the expected stage of test. If it is not as expected, a failure is indicated to the operator, much like any other potential defect such as; excessive pressure loss to atmosphere, leaks to adjacent ports or ramp test fail scenarios. Testing of changeover valves requires pressure decay testing at three different pressures, which is achieved using an automatic pressure regulator. Vacuum can also be applied if required.

FCS539內的一體式表壓開關可確保在預期的測試階段打開或關閉出口空氣。如果不符合預期，則向操作員指示故障，就像任何其他潛在缺陷一樣;大氣壓力損失過大，相鄰端口泄漏或斜坡測試失敗情況。轉換閥的測試需要在三種不同壓力下進行壓力衰減測試，這是使用自動壓力調節器實現的。如果需要，也可以施加真空。

The FCS539, provides you with a multifunction Leak Detection system which suits a wide variety of valve configurations and styles. It not only improves the quality and consistency of testing but also allows an increase in production speed.

FCS539為您提供多功能泄漏檢測系統，適用于各種閥門配置和樣式。它不僅提高了測試的質量和一致性，而且還提高了生產速度。

The optional barcode reading function on the FCO75x series of machines also allows you to trace batch ID, operator ID, product ID and serial number data points.

FCO75x系列機器上的可選條形碼讀取功能還允許您跟蹤批次ID，操作員ID，產品ID和序列號數據點

上一篇:Production Line Leak Detector (FCO750) 生產線檢漏儀（FCO750）

下一篇:Case Integrity/Combustion Soundness Tester (FCS510) 案例完整性/燃燒完好性測試儀