產品名稱：Flush Mount Differential Pressure Transmitter (FC0342)

Key Features

l  Flush mounted design for clean room applications

l  Accuracy < 0.5% of reading

l  Two wire system with current output

l  Stainless steel housing to IP64

l  PC configurable for range, display and calibration

l 嵌入式安裝設計，適用于潔凈室應用

l  準確度<讀數的0.5％

l  帶電流輸出的雙線系統

l  不銹鋼外殼，達到IP64

l  PC可配置范圍，顯示和校準

With the FCO342 flush mounted Differential Pressure Transmitter, Furness Controls provides an all in one pressure transmission and local indication solution, meeting the requirements of reduced cost, footprint and instrumentation on site. Both outputs of measurement ,which included the linear analogue signal and 4 digit display, are within 0.25% of accuracy at the operating pressure of 10 Pascal, or 0.03 Pascal in SI terms.

通過FCO342嵌入式差壓變送器，Furness Controls提供一體化壓力傳輸和本地指示解決方案，滿足現場降低成本，占地面積和儀器的要求。測量的兩個輸出，包括線性模擬信號和4位數顯示，在10帕斯卡的工作壓力下，精度的0.25％，或以SI表示的0.03帕斯卡。

The FCO342 uses the proven capacitance-based transducer design for long term reliability and repeatability.

FCO342采用成熟的基于電容的傳感器設計，具有長期可靠性和可重復性。

Quick installation and verification

Compared to other products, the FCO342 provides a quicker installation and ongoing verification process:

The linear output signal and display are verified with the Building Management System at a single source.

Integrated calibration ports to carry out instrument calibration without the need to disconnect the impulse lines, minimising disruption to ongoing processes.

Separate local indications are redundant, resulting in reduced instrumentation and subsequent calibration overhead.

快速安裝和驗證

與其他產品相比，FCO342提供更快的安裝和持續的驗證過程：

線性輸出信號和顯示器通過單一來源的樓宇管理系統進行驗證。

集成校準端口，無需斷開脈沖線即可進行儀器校準，最大限度地減少對正在進行的過程的干擾。

單獨的本地指示是多余的，導致儀器減少和隨后的校準開銷

上一篇:Pressure Relief Valve Tester (FCO750F) 泄壓閥測試儀（FCO750F）

下一篇:Panel Mount Differential Pressure Transmitter (FC0318) 面板安裝差壓變送器